Fence Picket Calculator
Enter your fence length, picket width and gap, and this fence picket calculator returns the picket count plus posts, rails and fasteners — with a waste allowance so one bad board does not send you back to the lumberyard.
Use the ACTUAL board width, not the nominal size: a 1x6 board is 5.5 inches wide, a 1x4 is 3.5 inches. Gap is 0 for a privacy fence.
Gate posts are counted in the post total, but gate widths are subtracted before counting pickets and rails so you do not buy boards for an opening.
How the fence picket calculator works
Three counts drive every wood fence: posts come from the spacing, pickets come from the board width plus the gap, and rails come from the sections. A 100-foot run at 8-foot post spacing needs 13 sections and therefore 14 posts — sections plus one end post, always.
Worked example: a 100-foot privacy fence with 5.5-inch pickets and no gap needs ceil(100 x 12 / 5.5) = 219 pickets, 14 posts, and 39 rails at 3 rails per section. With the default 10% waste allowance you buy 241 pickets. The same run as a spaced picket fence — 3.5-inch pickets with a 2.5-inch gap — needs only ceil(1200 / 6) = 200 pickets.
Common mistakes: using the nominal board size instead of the actual width (a 1x6 is 5.5 inches, not 6), forgetting to subtract gate widths before counting pickets, and skipping the waste allowance. Board-on-board and shadow-box styles need roughly 30-40% more pickets for the overlap — this calculator covers standard single-face fences.
pickets = ceil(run in inches / (picket width + gap)) · posts = ceil(run / spacing) + 1 · rails = sections x rails per section
Related tools
Also try the Fence Square Footage Calculator for the area, the Fence Post Spacing Calculator for layout, and the Fence Material Calculator for the full bill of materials.
Fence picket calculator FAQ
How many pickets do I need for a 100-foot fence?
With 5.5-inch pickets and no gap (privacy style), 219 pickets: 100 x 12 / 5.5 = 218.2, rounded up. Add 10% waste and buy 241. With a gap, divide by picket width plus gap instead.
How do I calculate pickets with a gap between them?
Add the picket width and the gap, then divide the run in inches by that sum and round up. A 3.5-inch picket with a 2.5-inch gap covers 6 inches per picket, so a 100-foot run needs 200 pickets.
Why is a 1x6 picket only 5.5 inches wide?
Lumber is sold by nominal size but planed smaller: a dry 1x6 measures 5.5 inches wide and a 1x4 measures 3.5 inches. Always enter the measured width, or your count will come up short.
How many posts do I need?
Divide the run by the post spacing, round up to whole sections, and add 1 for the end post. A 100-foot run at 8-foot spacing is 13 sections and 14 posts; at 6-foot spacing it is 17 sections and 18 posts.
How many rails per section?
Two rails for fences under 5 feet tall and three rails for 6-foot and taller fences is the standard rule. Taller or heavier fences sometimes use a mid-rail plus top and bottom, which is still 3.
Do I subtract gate widths?
Yes. Subtract every gate opening from the run before counting pickets and rails, or you will buy boards for an opening. Gate posts themselves stay in the post count.
How much waste should I add?
10% covers cuts, knots, splits and one or two bad boards on a straight run. Use 15% if the run has many corners, slopes or short cut sections.