Pond Liner Calculator
Enter your pond length, width and depth, and this pond liner calculator returns the liner size to buy, the underlayment to match it, and the water volume in gallons — using the maker formula every liner supplier publishes.
Planning estimate for a flexible-sheet liner (EPDM or PVC) in a dug pond. The depth is counted twice because the liner runs down one wall and up the other; the overlap is the flap left on the ground around the edge to anchor under rocks or edging. Shelves, ledges and irregular curves add liner the rectangle formula cannot see — measure the laid-out path before you buy.
How the pond liner calculator works
A flexible liner is one flat sheet that has to line the whole hole, so each side of the sheet is the pond dimension plus twice the maximum depth — once down one wall and once up the other — plus the overlap left lying on the ground around the edge to anchor under rocks or edging. The usual overlap is 12 inches at each edge, or 2 feet in total, which is the default here and the figure Firestone publishes for its PondGard liner; some suppliers allow 1 foot in total, so change the field if yours advises it. Pre-cut liners are mostly sold in 5-foot steps, and a liner that is too small cannot be stretched, so the calculator rounds each side up to the next 5 feet.
Worked example: a 10 by 8 foot garden pond, 2 feet at its deepest and 1.5 feet deep on average, with 12 inches of overlap at each edge, needs a liner of 10 + 4 + 2, or 16 feet, by 8 + 4 + 2, or 14 feet. Rounded up to 5-foot stock sizes that is a 20 by 15 foot liner, 300 square feet, with the same area of underlayment underneath it. The volume is 10 times 8 times 1.5, or 120 cubic feet, times 7.48 gallons per cubic foot — about 898 gallons.
Common mistakes: sizing the liner from the average depth instead of the maximum (the liner follows the deepest point, so a shallow average leaves the deep end short); forgetting the overlap entirely; and measuring a curved pond by its waterline instead of its longest and widest points — for an irregular shape, imagine the smallest rectangle that would contain it and size the liner to that, because the sheet folds into the curves. A round pond uses its diameter for both sides. The Pond Pump Running Cost Calculator sizes the pump that keeps this water moving.
liner length = pond length + 2 x max depth + 2 x overlap · liner width = pond width + 2 x max depth + 2 x overlap · volume (gal) = length x width x avg depth x 7.48
Related tools
Also try the Pond Pump Running Cost Calculator for the pump, the Pool Water Volume Calculator for a pool, and the Pool Square Footage Calculator for the area.
Pond liner calculator FAQ
What size liner do I need for a 10 x 8 ft pond?
At 2 feet deep with 12 inches of overlap at each edge: 16 by 14 feet exact, rounded up to a 20 by 15 foot stock liner. The formula is pond length plus twice the depth plus 2 feet of overlap, on each side.
How much overlap should I allow on a pond liner?
12 inches at each edge, or 2 feet in total, is the usual allowance and the default here. The Pond Guy allows 1 foot in total; a waterfall or stream edge may need up to 4 feet. More overlap is easy to trim; too little cannot be fixed.
Should I use the maximum depth or the average depth?
The maximum depth for the liner, the average depth for the volume. The liner has to reach the deepest point, while a pond with shelves holds less water than a box of the same size, so the average depth gives the truer gallon count.
Do I need underlayment under a pond liner?
Yes — buy the same area as the liner. The underlayment is a geotextile layer that protects the liner from sharp stones and roots underneath. Pondkeeper and most suppliers recommend matching the liner size.
How many gallons does my pond hold?
Multiply length by width by average depth in feet, then by 7.48 gallons per cubic foot. A 10 by 8 foot pond averaging 1.5 feet deep holds about 898 gallons. For a round pond, use pi times the radius squared times the average depth.
What liner material is best — EPDM or PVC?
45-mil EPDM rubber is the usual pick for garden and koi ponds: flexible in cold weather, 20 to 30-plus years of life, about $0.75 to $2.50 per square foot. PVC is cheaper and lighter but stiffer and shorter-lived. Check the material your supplier stocks.
What if my pond is an irregular shape?
Measure the longest and widest points and size the liner to that bounding rectangle — the sheet folds into the curves. For a round pond, enter the diameter; the liner is a square sheet sized on the diameter.